Not a whole lot of progress to report, but I`m still at it. Here are some new pictures.
Before making the lip around the opening,
This is the bracket for the rear headrest fastener.
This opening is for access to the transmission linkage.
Access to the gas tank.
In this picture you can see the fastener for the headrest and the gas cap.
As you can see in this picture, I`ve been grinding the welds on the panels that were added to lengthen the tank. This has taken longer than I thought it would.
This picture shows the steering wheel as a raw casting,
and here it is after I drilled a few holes in it and polished it.